When you are experiencing the issue of broken garage door springs that need to be replaced you can either call professional garage door technicians or do it on your own.

Garage door springs are long, heavy, and hard-to-handle devices that are used to lift and lower the weight of the garage door.  Garage door torsion spring installation can be a hard and challenging process that should be left to professional garage door experts. If your garage door has broken springs that need to be taken care of you should exercise all required safety measurements. The following mentioned are the steps that you can follow to get the job done in the right way. These points will also help you to ensure that the project can be done easily and the garage door will work properly.

The most important point that you need to keep in mind is to ensure that you have disconnected the power supply to the garage door so you do not get electrocuted while performing the work. You should turn off the power cord of the garage door opener along with disconnecting it from the garage door. This rule is for newer garage door models. With older models of garage doors, you may need to remove the fuse or turn off the circuit breaker to disconnect the power supply.

Look closely at the broken garage door torsion spring and the new one to make sure that they are both the same. Confirm that both of them are the same in type, size, and dimension to make the garage door functional smoothly. While picking a new spring, avoid grabbing them with each other. Don’t touch the winding cones of the new springs for your personal safety. Use any writing instrument to mark the torsion shaft ends. You need to do it because it helps you to make sure that you have a properly aligned garage door when you have completed the project of broken garage door spring replacement.

Wind the unbroken spring off and unfasten the screws and bolts that are used to secure the torsion cones and spring mounting brackets together. Then remove the bolts completely. Once you have completed the process of removing the broken garage door spring, it is time to install a new spring along with installing the hardware. Once you have done the process, it is time to wind up the new spring. After finishing the entire task, you need to check and test the garage door to make sure that the garage door is balanced correctly. In order to reduce the amount of friction, you need to apply some lubrication.

Once you have checked the garage door make sure that it is aligned correctly and all the components are tightened and in place. It is time to reconnect the garage door opener. It is true that you should not play with the garage door but you need to open and close the garage door a few times to make sure it is working correctly. it is easy to replace the broken garage door springs on your own if you have the right skills and tools. You need to make sure that you are doing a job correctly because it can be dangerous if you are not careful. You could lose your hand, legs, or even life. Therefore, it is suggested to call professional help.